Table of Contents
Advertisement
• Location
(2)
(1) 10 mm (0.39 in)
(2) 40 mm (1.57 in)
Make clearance for 10 mm from instrument panel
front edge, and 40 mm from both side edges when
taping.
2. STEERING SUPPORT BEAM
1) Temporarily tighten the steering support beam
with bolt, and then route the harness.
2) Make sure that there is no mutual interference in
each pedal, and then tighten each bolt.
Tightening torque:
⋅
25 N
m (25.5 kgf-m, 18.4 ft-lb)
3) Install in the reverse order of removal.
3. INSTRUMENT PANEL ASSEMBLY (IN-
CLUDING STEERING SUPPORT BEAM)
1) Insert the matching pins (three places) on the in-
strument panel tip into the grommet (A) and (B) on
the body panel side.
(B)
(A)
2) Check that the matching pins are inserted se-
curely, and then route the harness.
3) Temporarily tighten the steering support beam
with bolt, and then route the harness.
4) Make sure that there is no mutual interference in
each pedal, and then tighten each bolt.
Tightening torque:
⋅
25 N
m (25.5 kgf-m, 18.4 ft-lb)
5) Install in the reverse order of removal.
Instrument Panel Assembly
(1)
(2)
EI-01087
(B)
EI-00621
EI-59
EXTERIOR/INTERIOR TRIM
Advertisement
Chapters
Table of Contents
