Subaru Legacy 2005 Service Manual page 3900

SECURITY AND LOCKS
3. Keyless Entry System
A: WIRING DIAGRAM
1. KEYLESS ENTRY
<Ref. to WI-319, WIRING DIAGRAM, Keyless Entry System.>
B: ELECTRICAL SPECIFICATION
1. CUSTOMIZE SETTING OF SELECT UNLOCK
Switching from all door unlock to select unlock, or select unlock to all door unlock are performed with follow-
ing procedure.
1) Close the driver's door, and then open it.
2) Insert the key to ignition switch, and then turn the ignition switch from OFF to ON for more than 10 times
within 15 seconds. Complete the procedure in step 1) through 2) within 45 seconds. When the procedures
are completed correctly, the buzzer beeps once. If the buzzer does not beep, repeat the procedures from
step 1).
3) Close the driver's door.
4) While depressing the door lock switch to lock side, turn the ignition switch from OFF to ON.
5) While depressing the door lock switch to unlock side, turn the ignition switch from ON to OFF, and then re-
lease the door lock switch. Complete the procedure in step 3) through 5) within 30 seconds. When the pro-
cedures are completed correctly, the buzzer beeps twice and door lock, unlock operates automatically. When
the buzzer does not beep, repeat the procedures from step 1).
6) Remove the key from ignition switch, and then complete the procedure.
7) Operate the key button to check that the setting is changed.
2. KEYLESS ENTRY CONTROL MODULE
To
4 3 2 1
8 7 6 5
Remarks
Body integrated module
Power supply (Backup)
Ground
Keyless Entry System
i96
SL-00228
Terminal No.
3 (OUTPUT) Battery voltage cannot be measured because of digital signal.
4 Battery voltage is constantly present.
7 0 V is constantly present.
Measuring conditions
SL-14