Subaru Legacy 2005 Service Manual page 3701

Step
9 CHECK SEAT BELT WARNING SYSTEM.
1) Lift-up the vehicle.
NOTE:
Raise all wheels off floor.
2) Insert the tongue plate of driver's seat belt
into seat belt buckle.
3) Hold the tang plate of passenger's seat belt
disconnected from seat belt buckle.
4) Start the engine, and set the vehicle speed
to more than 24 km/h (15 MPH).
NOTE:
The speed difference between front and rear
wheels may light the ABS or VDC warning light,
but this indicates no malfunction. When diagno-
sis is finished, perform the clear memory mode
for ABS or VDC. <Ref. to ABS(diag)-15, OPER-
ATION, Subaru Select Monitor.> or <Ref. to
VDC(diag)-16, OPERATION, Subaru Select
Monitor.>
10 CHECK SEAT BELT WARNING SYSTEM.
While the seat belt warning light is blinking and
the buzzer is beeping, decelerate the vehicle
speed to less than 21 km/h (13 MPH).
11 CHECK SEAT BELT WARNING SYSTEM.
1) Set the vehicle speed to more than 24 km/h
(15 MPH).
2) Wait for approx. 108 seconds while the seat
belt warning light is blinking and the buzzer is
beeping.
NOTE:
The speed difference between front and rear
wheels may light the ABS or VDC warning light,
but this indicates no malfunction. When diagno-
sis is finished, perform the clear memory mode
for ABS or VDC. <Ref. to ABS(diag)-15, OPER-
ATION, Subaru Select Monitor.> or <Ref. to
VDC(diag)-16, OPERATION, Subaru Select
Monitor.>
Seat Belt Warning System
Does the seat belt warning
light blink and the buzzer
beep?
Does the buzzer stop beeping
and the seat belt warning light
change from blinking to illumi-
nating?
Does the buzzer stop beeping
and the seat belt warning light
change from blinking to illumi-
nating?
SB-13
Check
Go to step 10.
Go to step 11.
The seat belt
warning light sys-
tem is normal.
A temporary poor
contact of har-
ness connector
may be the cause.
Check the poor
contact.
SEAT BELT SYSTEM
Yes No
Check the body
integrated module.
Check the body
integrated module.
Check the body
integrated module.