Subaru Legacy 2005 Service Manual page 3884

SEATS
5) Loosen the screws to remove armrest from
backrest assembly RH.
NOTE:
The armrest cannot be removed when the backrest
assembly RH side does not mate with the armrest
pin position.
6) After this operation, refer to the step 2) to disas-
semble the backrest assembly RH
7) Remove the hook and detach armrest cover.
8) Remove the hook and hog rings and detach
headrest cover.
Rear Seat
9) Remove the hog rings (A) on the rear side of
seat cushion.
SE-00358
10) Remove the hog rings (A), and then remove the
seat cushion cover.
D: ASSEMBLY
Assemble in the reverse order of disassembly.
NOTE:
• Do not contaminate or damage the cover.
SE-00356
• While installing the hog rings, prevent the seat
from getting wrinkled.
CAUTION:
• Always use new hog rings.
• Secure the hog ring using hog ring pliers.
• Install the hog rings to the specified points
securely and make sure that no wrinkle or twist-
ing on the backrest cover.
E: INSPECTION
Check that no tear or fray on the seat cover.
SE-00357
SE-18
: (A)
SE-00399
: (A)
SE-00398