LAN SYSTEM (DIAGNOSTICS)
7) Perform the Factory setting. On the "ECM cus-
tomizing" display screen of Subaru Select Monitor,
select the {Factory initial setting} and press the
[YES] key.
8) Change the mode from Factory into Market.
9) Replace the immobilizer cartridge, and register
the immobilizer key. (Model with immobilizer)
10) Perform the registration according to the proce-
dures of "IMMOBILIZER TEACHING OPERATION
MANUAL".
11) When key registration is completed, "Do you
want to register remote engine start?" is displayed.
Press the [NO] key to finish the registration.
12) Perform the function setting (ECM customiz-
ing).
<Ref. to LAN(diag)-21, FUNCTION SETTING
(ECM CUSTOMIZING), OPERATION, Subaru Se-
lect Monitor.>
NOTE:
For details concerning operation procedure, refer
to the SUBARU SELECT MONITOR OPERATION
MANUAL.
7. CLEAR MEMORY MODE
1) On the "Main Menu" display screen, select the
{2. Each System Check} and press the [YES] key.
2) On the "System Selection Menu" display screen,
select the {Integ. unit mode} and press the [YES]
key.
3) Press the [YES] key after the information of body
integrated module type is displayed.
4) On the "Integ. unit mode failure diag" display
screen, select the {Clear Memory} and press the
[YES] key.
Display
Clear memory?
5) When the "Done" are shown on the display
screen, turn the ignition switch to OFF.
NOTE:
For details concerning operation procedure, refer
to the SUBARU SELECT MONITOR OPERATION
MANUAL.
Subaru Select Monitor
Contents to be monitored
Clear function of DTC and
freeze frame data
LAN(diag)-20
8. FREEZE FRAME DATA
NOTE:
• Data stored at the time of trouble occurrence is
shown on display.
• Freeze frame data will be memorized maximum
to 20.
• If freeze frame data is not stored in memory cor-
rectly (caused by low power supply of body inte-
grated module), DTC will be displayed with "?" on
the head of it in the Subaru Select Monitor display.
This shows it may be an unreliable reading.