Subaru Legacy 2005 Service Manual page 4009

15) Disconnect the connectors, and remove the in-
strument panel from vehicle body.
NOTE:
• If necessary, make matching marks for easy re-
assembly.
• When storing the removed instrument panel, be
sure to prepare a table or the like to put instrument
panel on to prevent damage.
16) Remove the side air vent grille. <Ref. to AC-46,
REMOVAL, Air Vent Grille.>
17) Remove the heater vent duct. <Ref. to AC-48,
REMOVAL, Heater Vent Duct.>
18) Loosen the screws to remove center console
frame.
19) Loosen the screws to remove meter bracket.
20) Loosen the screws to remove instrument panel
matching pins.
Instrument Panel Assembly
21) Loosen the screws to remove glove box striker.
22) Remove the pawl, and remove the passenger's
airbag module.
EI-00774
2. STEERING SUPPORT BEAM
1) Remove the instrument panel. <Ref. to EI-56,
INSTRUMENT PANEL (EXCLUDING STEERING
SUPPORT BEAM), REMOVAL, Instrument Panel
Assembly.>
2) Remove the steering shaft assembly. <Ref. to
PS-24, REMOVAL, Tilt Steering Column.>
3) Remove each harness clip, and remove the har-
ness from steering support beam.
NOTE:
If necessary, make matching marks for easy reas-
EI-00612
sembly.
4) Remove the bolts and remove steering support
beam.
EI-00613
EI-57
EXTERIOR/INTERIOR TRIM
EI-00614
EI-00615
EI-00775