Subaru Legacy 2005 Service Manual page 3816

Hide thumbs Also See for Legacy 2005:

Table of Contents

GLASS/WINDOWS/MIRRORS

7) After adjusting the clearance from center pillar,

move the glass up and down the glass several

times to check glass contact condition against stop-

per when the glass is fully closed. Adjust so that the

front and rear stoppers contact simultaneously.

(3) When the stopper of door sash (front) contacts

(4) When the stopper of door sash (rear) contacts

(5) Raise B channel

(6) Lower B channel

Front Door Glass

8) To adjust the glass stroke, attach the ST to

glass, close the door, and raise the glass to the up-

per end of it with regulator until the positional rela-

tionship between glass and weather strip becomes

the value as shown in the figure. Secure the glass

so that the upper stopper correctly touches the

glass holder.

ST 61299AE000 SPACER (Glass thickness: 5

(1) 3.2 — 4.8 mm (0.126 — 0.189 in)

(2) When reusing weather strip: 5.5 mm (0.217 in)

With new weather strip: 3 mm (0.118 in)

To prevent generating wind noise, adjust the glass

in the position where tip of gusset is raised up a lit-

(A) 0 — 1.5 mm (0 — 0.059 in)

9) After stabilizer adjustment, carry out the glass

cohesion adjustment. First, visually check the posi-

tional relationship between retainer & molding and

roof side glass, and then begin with rear sash ad-

justment. Attach the ST to glass, and adjust the two

adjusting bolts alternately step by step to obtain di-

mensions shown below (cross-section A).

If two nuts are loosened at the same time, the sash

will move back and forth.Therefore, while adjusting

one nut, secure the other.

mm (0.197 in) for front door

Chapters

Table of Contents