Table of Contents
Advertisement
10) Make the same adjustment of two adjusting
bolts of rear sash.
ST 61299AE000 SPACER (Glass thickness: 5
mm (0.197 in) for front door
glass)
A
A
(1) 3.2 — 4.8 mm (0.126 — 0.189 in)
(2) When reusing weather strip: 5.5 mm (0.217 in)
With new weather strip: 3 mm (0.118 in)
(3) ST
NOTE:
Do not tilt the sash bracket toward inner panel dur-
ing adjustment. Otherwise smooth regulator opera-
tion cannot be achieved.
(1)
(2)
(1) Sash bracket
(2) Rear sash
(3) Adjust the lines parallel
(4) Sash
(5) Inner panel
11) Make adjustment of front sash in the same
manner as that of rear sash.
NOTE:
Although front and rear sashes must, as a rule, be
adjusted in the same manner, in some door instal-
lation, the adjustment in a different manner may be
required. However, adjustment of one sash to the
maximum amount and the other to the minimum
amount is not permitted. Such adjustment may re-
sult in application of excessive load to regulator.
12) After adjustments, tighten the nuts.
Front Door Glass
(1)
(2)
(3)
A-A
GW-00430
(4)
(3)
(5)
GW-00270
GW-15
GLASS/WINDOWS/MIRRORS
13) After adjustment of the glass, close the door. If
there is a gap between outer lip of gusset and glass
surface, adjust the gap with adjusting bolt (A) in
lower fitting part of gusset to prevent generation of
wind noise.
14) During adjustment, loosen other three clamp-
ing bolts.
15) After adjustment, tighten the bolts and nuts.
(A)
GW-00271
Advertisement
Chapters
Table of Contents
