Subaru Legacy 2005 Service Manual page 4014

EXTERIOR/INTERIOR TRIM
25.Upper Inner Trim
A: REMOVAL
1) Remove the metal clip from the top side of trim,
using a flat tip screwdriver.
CAUTION:
When the metal clip has been removed or dam-
aged, replace both of the trim and metal clips
with new ones.
2) Remove the front pillar upper trim.
3) Remove the front inside scuff plate, rear inside
scuff plate and center pillar lower trim. <Ref. to EI-
60, REMOVAL, Lower Inner Trim.>
4) Remove the cap on the upper side of pillar trim,
and remove the bolt inside. (Model with curtain air-
bag)
Upper Inner Trim
5) Remove the center pillar upper trim.
6) For driver's side, push the claw (A) in the back-
side of center pillar upper trim to both right and left
side, and lower the mini slider (B) into the direction
EI-00785
of arrow.
7) Remove the seat belt lower anchor bolt or lap
seat belt pretensioner (Model with lap seat belt pre-
tensioner), and pull out the seat belt from center pil-
lar upper trim.
EI-00786
B: INSTALLATION
Install in the reverse order of removal.
EI-00562
EI-62
EI-00787
(B)
(A)
EI-01167
SB-00145