Subaru Legacy 2005 Service Manual page 3882

SEATS
B: INSTALLATION
1. SEDAN MODEL
Install in the reverse order of removal.
NOTE:
• After backrest installation, make sure that each
seat belt operates normally.
• Make sure that they are secured on each hook of
vehicle side.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-4, REAR SEAT (SEDAN
MODEL), COMPONENT, General Descrip-
tion.>
2. WAGON MODEL
Install in the reverse order of removal.
NOTE:
• After backrest installation, make sure that each
seat belt operates normally.
• Make sure that they are secured on each hook of
vehicle side.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-5, REAR SEAT (WAGON
MODEL), COMPONENT, General Descrip-
tion.>
C: DISASSEMBLY
1. SEDAN MODEL
1) Remove the rear seat. <Ref. to SE-14, SEDAN
MODEL, REMOVAL, Rear Seat.>
2) Remove the headrest.
3) Remove the nuts, and then detach the trunk
through assembly.
Rear Seat
4) Remove the hog rings (A) on the rear side of
backrest.
5) Remove the hog rings (A) on the front side of
backrest.
6) Remove both sides of armrest hinge covers, and
loosen the screws to remove armrest.
7) Remove the hook and detach center through
cover.
SE-00347
SE-16
: (A)
: (A)
SE-00352
SE-00353
SE-00354
SE-00355