Subaru Legacy 2005 Service Manual page 3752

LIGHTING SYSTEM
35.Ignition Switch Illumination
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the screws and detach the upper col-
umn cover and lower column cover.
3) Remove the instrument panel lower cover. <Ref.
to EI-50, REMOVAL, Instrument Panel Lower Cov-
er.>
4) Disconnect the ignition switch illumination con-
nector (A).
5) Turn the ignition switch illumination connector to
left and remove it.
(B)
(C)
(A) Ignition switch illumination connector
(B) Ignition switch illumination
(C) Immobilizer antenna connector
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Step
1 CHECK IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination illu-
minates when driver's side door is open.
2 CHECK IGNITION SWITCH ILLUMINATION.
Make sure the ignition switch illumination
blinks when ignition switch is turned to ON.
Ignition Switch Illumination
SL-00258
(A)
LI-00343
Does the ignition switch illumi-
nation illuminate?
Does the ignition switch illumi-
nation blink?
LI-40
Check
Ignition switch illu-
mination is normal.
Check the func-
tion setting of body
integrated mod-
ule. <Ref. to
LAN(diag)-2, Basic
Diagnostic Proce-
dure.>
Yes No
Go to step 2.
Check the ignition
switch illumination
circuit. <Ref. to
SL-25, CHECK
IGNITION
SWITCH ILLUMI-
NATION, INSPEC-
TION, Keyless
Entry System.>