Subaru Legacy 2005 Service Manual page 3708

Hide thumbs Also See for Legacy 2005:

Table of Contents

SEAT BELT SYSTEM

• After deployment, the pretensioner is espe-

cially hot, leave it unattended for 40 minutes or

• Do not let water get in the deployed preten-

11) For the model with lap seat belt pretensioner,

proceed to operation 12) to 17).

12) Disconnect the orange connector (a) from lap

seat belt pretensioner.

13) Connect the deployment tool (A) and deploy-

ment adapter F (B).

The terminals of deployment tool should be

kept shorted until just before deploying the pre-

(A) Deployment tool:

(Tool number 98299PA030)

(B) DEPLOYMENT ADAPTER F:

(Tool number 98299SA050)

14) Connect the deployment adapter F connector

and orange connector of lap seat belt pretensioner.

Disposal of Pretensioner

15) Extend the wiring of deployment tool to the lim-

it, and make sure that the vehicle is empty. Close

all windows, sunroof and rear gate completely.

16) Move the battery at least 5 m (16 ft) away from

vehicle, and secure to the nearby area. Connect

the deployment tool alligator clip to the battery neg-

ative (−) terminal

17) Connect the other cable of deployment tool to

the battery positive (+) terminal, and deploy the

pretensioner.

• After deployment, the pretensioner is espe-

cially hot, leave it unattended for 40 minutes or

• Do not let water get in the deployed preten-

18) Remove the front outer belt. <Ref. to SB-14,

REMOVAL, Front Seat Belt.>

19) Cut off the seat belt as close to seat belt retrac-

tor as possible.

Chapters

Table of Contents