Subaru Legacy 2005 Service Manual page 4114

Clear Memory Mode
IMMOBILIZER (DIAGNOSTICS)
7. Clear Memory Mode
A: OPERATION
1. ENGINE ECM
1) On the "Main Menu" display screen, select the
{Each System Check} and press the [YES] key.
2) On the "System Selection Menu" display screen,
select the {Engine Control System} and press the
[YES] key.
3) Press the [YES] key after the information of en-
gine type is displayed.
4) On the "Engine Diagnosis" display screen, select
the {Clear Memory} and press the [YES] key.
5) When the "Done" are shown on the display
screen, turn the Subaru Select Monitor and ignition
switch to OFF.
NOTE:
• After the memory has been cleared, the idle air
control solenoid valve must be initialized. To exe-
cute this procedure, turn the ignition switch to ON.
Wait for 3 seconds before starting the engine.
• For detailed operation procedure, refer to the
SUBARU SELECT MONITOR OPERATION MAN-
UAL.
2. BODY INTEGRATED MODULE
1) On the "Main Menu" display screen, select the
{Each System Check} and press the [YES] key.
2) On the "System Selection Menu" display screen,
select the {Integ. unit mode} and press the [YES]
key.
3) Press the [YES] key after the {Integ. unit mode}
is displayed.
4) On the "Integ. unit mode failure diag" display
screen, select the {Clear Memory} and press the
[YES] key.
5) When the "Done" are shown on the display
screen, turn the Subaru Select Monitor and ignition
switch to OFF.
NOTE:
For detailed operation procedure, refer to the SUB-
ARU SELECT MONITOR OPERATION MANUAL.
IM(diag)-10