Rear Combination Light Assembly - Subaru Legacy 2003 Service Manual

LIGHTING SYSTEM
18.Rear Combination Light As-
sembly
A: REMOVAL
1. SEDAN
1) Disconnect ground cable from battery.
2) Remove clips and then detach trunk rear trim.
3) Remove hook (A) and then turn over the trunk
side trim of rear portion.
( A )
4) Remove harness clip (A).
5) Remove three nuts and then detach rear combi-
nation light while disconnecting connector.

REAR COMBINATION LIGHT ASSEMBLY

LI-00091
LI-00092
LI-00093
2. WAGON
1) Disconnect ground cable from battery.
2) Remove two rear quarter trim covers.
3) Remove two nuts and then remove rear combi-
nation light while disconnecting connector.
NOTE:
Before removing the nuts, apply a few turns of butyl
tape to the tip of the service tool. This prevents the
nuts from falling during removal.
B: INSTALLATION
Install in the reverse order of removal.
LI-22
LI-00094