Subaru Legacy 2005 Service Manual page 3927

17.Ignition Key Lock
A: REPLACEMENT
1) Disconnect the ground cable from battery.
2) Remove the steering column. <Ref. to PS-24,
REMOVAL, Tilt Steering Column.>
3) Secure the steering column in a vise. Remove
the bolt with a drill.
4) Remove the ignition key lock.
5) Using a new bolt, tighten the bolts all the way.
Ignition Key Lock
B: INSPECTION
1) Remove the instrument panel lower panel.
2) Remove the lower column cover.
3) Unfasten the fixing clip which secures harness,
and then disconnect the connector of the ignition
switch from body harness.
4) Turn the ignition key plate to each position and
check the continuity between terminals of ignition
connector.
SL-00024
Switch position
If NG, replace the ignition switch.
SL-00025
SL-41
SECURITY AND LOCKS
3 2 1
6 5 4
Terminal No.
LOCK —
ACC No. 3 and No. 4
No. 3 and No. 1
ON and No. 4
No. 3 and No. 6
No. 3 and No. 1
ST No. 3 and No. 2
and No. 6
SL-00266
Standard
—
Less than 1 Ω
Less than 1 Ω
Less than 1 Ω