Subaru Legacy 2005 Service Manual page 3709

20) Wrap the deployed pretensioner in airtight vinyl
bag to discard.
2. DEPLOYING OF PRETENSIONER AF-
TER REMOVAL FROM VEHICLE
1) Fold the backrest all the way forward, and then
move the front seat all the way forward.
2) Turn the ignition switch to OFF, disconnect the
battery ground terminal, and wait more than 20
seconds.
3) Remove the front outer belt. <Ref. to SB-14, RE-
MOVAL, Front Seat Belt.>
4) Cut off the seat belt as close to seat belt retractor
as possible.
5) Short the terminal to alligator clip of deployment
tool.
Disposal of Pretensioner
6) Connect the deployment tool (A) and deploy-
ment adapter D (B).
CAUTION:
The terminals of deployment tool should be
kept shorted until just before deploying the pre-
tensioner.
SB-00131
7) Connect the deployment adapter D connector
and pretensioner connector.
8) Install the pretensioner on a wheel with tire.
Then, bundle three automotive wire harness [each
with a sectional area of 1.25 mm
more], and bind them twofold around the preten-
sioner bracket and wheel.
SB-00130
9) Put three tires without wheel on the tire installed
with pretensioner. Put on an additional tire with a
wheel on top, and then fasten them tight with a
rope.
SB-21
(A)
(B)
(A) Deployment tool:
(Tool number 98299PA030)
(B) Deployment adapter D:
(Tool number 98299SA010)
SEAT BELT SYSTEM
SB-00021
2
(0.00194 sq in) or
SB-00024
SB-00025