Subaru Legacy 2005 Service Manual page 3879

Hide thumbs Also See for Legacy 2005:
Table of Contents

Advertisement

D: ASSEMBLY
CAUTION:
When the backrest cover is not installed se-
curely, the side airbag module may not be de-
ployed properly, therefore keep strictly to the
following procedure.
• Be careful not to stain or damage the back-
rest cover during assembly.
• Always use new hog rings.
• Secure the hog ring using hog ring pliers.
• Install the hog rings to the specified points
securely and make sure that no wrinkle or twist-
ing on the backrest cover.
1. MANUAL SEAT
NOTE:
• When installing the inner seat belt assembly, fol-
low the procedure described in "Front Seat Belt".
<Ref. to SB-15, INNER SEAT BELT ASSEMBLY,
INSTALLATION, Front Seat Belt.>
• Install the backrest assembly and seat cushion
assembly in the following procedure.
1) Temporarily tighten the four reclining hinge
bolts.
2) Place the backrest in the most upright posi-
tion.(For manual seat, ensure the reclining mecha-
nism locked securely.)
3) Tighten the reclining hinge bolts (1) — (4) in two
or three steps by gradually increasing the torque
until they reach the specified torque.
(1)
(A)
(B)
(A) Vehicle inside
(B) Vehicle outside
4) Assemble in the reverse order of disassembly.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to SE-2, COMPONENT, General
Description.>
(2)
(4)
(3)
SE-00514
Front Seat
2. POWER SEAT
Assemble in the reverse order of disassembly.
NOTE:
Refer to "MANUAL SEAT" for installation of back-
rest assembly and seat cushion assembly. <Ref. to
SE-13, MANUAL SEAT, ASSEMBLY, Front Seat.>
E: INSPECTION
1. SEAT COVER
Check that no tear or fray on the backrest cover
and seat cushion cover.
NOTE:
For the model equipped with side airbag, when the
door side of backrest cover is torn or frayed, the
side airbag may not be deployed properly. Replace
it with new one in such a case.
2. SEATING SENSOR
Make sure the passenger's seat belt warning light
illuminates when applying load to the rear surface
of passenger's seat cushion. If not, replace the seat
cushion pad with a new one.
SE-13
SEATS
SE-00418

Advertisement

Table of Contents
loading

Table of Contents