Rear Combination Light Assembly - Subaru 2009 IMPREZA Service Manual

17.Rear Combination Light
Assembly
A: REMOVAL
1. 4 DOOR MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk room side trim. <Ref. to EI-61,
REMOVAL, Trunk Room Trim.>
3) Remove the harness connector and four nuts,
and remove the rear combination light.
2. 5 DOOR MODEL
1) Disconnect the ground cable from the battery.
2) Remove the two bolts, and then detach the rear
combination light by pulling it to the rear side of ve-
hicle.
3) Disconnect the harness connector and rear
combination light.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
7.5 N·m (0.76 kgf-m, 5.5 ft-lb)

Rear Combination Light Assembly

LI-00834
LI-00817
LI-23
C: INSPECTION
1. 4 DOOR MODEL
1) Visually check the bulb for blow out.
2) Check the bulb specification. <Ref. to LI-2,
SPECIFICATION, General Description.>
3) If NG, replace the bulb with a new part.
2. 5 DOOR MODEL
1) Install the rear combination light assembly and
check that it blinks normally.
2) If it does not blink normally, replace the rear
combination light assembly with a new part.
NOTE:
Since LED (Light Emitting Diode) is used for the tail
light/stop light bulb, replace the rear combination
light assembly if the LED burns out.
LIGHTING SYSTEM