Subaru Legacy 2005 Service Manual page 4148

LAN SYSTEM (DIAGNOSTICS)
6. REGISTRATION BODY INTEGRATED
MODULE (EQUIPMENT SETTING)
CAUTION:
Body integrated module is core of LAN system,
and also can select the function of all vehicle
system control. It is possible to control the
original functions of vehicle when registrations
of body integrated module and function setting
are corresponded to vehicle equipment.
If registrations and function setting are differ-
ent from vehicle equipment, vehicle system
does not operate normally and diagnosis can-
not be performed correctly. Pay attention to
items below.
• Be sure to correspond registrations and
function settings to vehicle equipment.
• Do not change the settings of vehicle improp-
erly.
• Confirm key illumination does not blink or
"Factory initial setting" of body integrated
module registrations is "Market". If "Factory
initial setting" is set to "Factory", key illumina-
tion blinks with ignition key turned to ON to
give warning of unconfirmed settings.
• Key illumination does not blink with ignition
switch turned to ON and go off with door
closed.
• Be sure to register immobilizer if body inte-
grated module is replaced with a new one.
(Model with immobilizer)
• Make a registration of immobilizer when the
parts related to immobilizer have been re-
placed. Refer to "IMMOBILIZER TEACHING OP-
ERATION MANUAL".
1) Turn the ignition switch to OFF.
2) Connect the Subaru Select Monitor to data link
connector.
Subaru Select Monitor
3) Turn the ignition switch to ON and the Subaru
Select Monitor power switch to ON.
4) On the "Main Menu" display screen, select the
{Each System Check} and press the [YES] key.
5) On the "Each System Check" display screen, se-
lect the {Integ. unit mode} and then select the "ECM
customizing".
LAN00110
LAN(diag)-18
(A) Power switch
(A)
LAN00017