Chery T21 2014 Service Manual page 446

07 - SQR484F ENGINE MECHANICAL
Removal
CAUTION
 Be sure to wear necessary safety equipment to prevent accidents when repairing.
 Try to prevent body paint surface from being scratched during removal and installation.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the engine trim cover assembly
4. Remove the engine lower right protector assembly
5. Remove the accessory drive belt.
a. Put the 15# open wrench (or socket) through area between engine and right side rail, and clamp the
tensioner pulley bolt.
07
b. Rotate the open wrench counterclockwise firmly in the
direction of arrow as show in the illustration. Loosen
the accessory drive belt (1) after it is loosened.
c. Carefully remove the accessory drive belt.
Inspection
1. Check belt surface for pilling, oiliness and deterioration, etc. If any of the defects is found, replace the
accessory drive belt.
2. Check the Internal and edge of belt for damage, wear, foreign matter and cracks, etc. If any of the defects
is found, replace the accessory drive belt.
HINT:
 Cracks on the rib side of accessory drive belt are
considered acceptable. If the accessory drive belt has
chunks missing from ribs, it should be replaced.
 After installing the accessory drive belt, check that it
fits properly in the ribbed grooves. Check that the belt
has not slipped out of grooves on the bottom of the
crankshaft pulley by hand.
24
07–
(See page 10-10).
(See page 48-29).
Chery Automobile Co., Ltd.
1
RT21160060
Right Wrong Wrong
RT21070030