Troubleshooting Guide
If you have trouble using the emulation probe, the following steps may help
you identify the problem:
Step 1: Telnet to the emulation probe
Use telnet to connect to the emulation probe across the LAN. (For
instructions on how to do this, see "Verifying LAN Communications" on
page 38.
The emulation probe must be reachable via LAN before you can use it.
If you cannot connect to the emulation probe
If you cannot ping or telnet to the emulation probe ("Verifying LAN
Communications" on page 38):
• See "Problems with the LAN Interface" on page 97.
• If you need to change the LAN parameters of the emulation probe, see
Chapter 2, "Connecting the Emulation Probe to a LAN," on page 25.
Step 2: Check the prompt
Once you have connected to the emulation probe, press the Enter key a few
times and look at the prompt which is displayed.
If a telnet connection to the emulation probe
displays the prompt "->"
The "->" prompt indicates that the firmware loaded into the emulation probe is
not compatible with the "target board adapter" which is located inside the
emulation probe.
Try one of the following until you get a different prompt:
E5900B / E5901B User's Guide Supplement
Troubleshooting the Emulator
Troubleshooting Guide
85