Configure Subsystem; Configure The Adjacent Channel Power Measurements; Configure The Channel Power And Density Measurements; Configure The Emission Bandwidth Measurements - Agilent Technologies ESA-E Series Programmer's Manual

Language Reference

CONFigure Subsystem

CONFigure Subsystem
CONFigure subsystem commands apply only to measurements found in
the menu. These commands stop the current measurement
MEASURE
and set up the instrument for the specified measurement using the
factory default instrument settings.
:CONFigure:<measurement> will always set :INITiate:
CONTinuous OFF (single mode), and also places the measurement in
the idle state.
:CONFigure:SANalyzer causes the present measurement to exit
(functionally the same as pressing ), and places the
MEASURE, Meas Off
analyzer in base instrument spectrum analyzer state.
The query :CONFigure? returns the current measurement name in
quotes.
Configure the Adjacent Channel Power Measurements
:CONFigure:ACPower
Configure the Channel Power and Density Measurements
:CONFigure:CHPower
Configure the Emission Bandwidth Measurements
:CONFigure:EBWidth
Configure the Harmonic Distortion Measurements
:CONFigure:HARMonics[:<number>]
Configure the OBW and Transmit Frequency Error
Measurements
:CONFigure:OBWidth
Chapter 5 5-37