Dual-Port Channelized T1 Or E1 Pim - Juniper J4350 Getting Started Manual

J4350 and J6350 Services Router Getting Started Guide
For pinouts of cable connectors for T1 and E1 PIMs, see "E1 and T1
RJ-48 Cable Pinouts" on page 196.
For alarms, see the configuring and monitoring alarms information in
the J-series Services Router Administration Guide.
For installing and removing a PIM, see "Replacing a PIM" on page 144.
Status LEDs indicate port status. Table 17 describes the meaning of the LED states.
Table 17: Status LEDs for T1 and E1 Ports

Dual-Port Channelized T1 or E1 PIM

The Dual-Port Channelized T1 or E1 PIM (Figure 15) is a multiflex interface card
that allows you to configure a single interface as a channelized T1 interface or a
channelized E1 interface. The channelized T1 or E1 interface supports up to 24 DS0
channels on a T1 interface and up to 32 DS0 channels on an E1 interface, in addition
to supporting the features of regular (unchannelized) T1 and E1 PIMs. Each interface
can be configured as a single clear channel, fractionalized, or channelized interface.
NOTE: You cannot configure a channelized T1 or E1 interface through a J-Web Quick
Configuration page.
36
Field-Replaceable PIMs
G.703, G.704, and G.706 E1 standards compliance
Independent internal and external clocking system
Loopback, bit error rate test (BERT), T1 facilities data link (FDL), and long
buildout diagnostics
Color State
Green
On steadily
Red On steadily
Unlit Off
Description
Online with no alarms or failures.
Active with a local alarm. The router has
detected a failure.
Offline.