Table of Contents
Advertisement
Example usage:
DAS-3626:admin#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
Neighbor
-------------------------------
FE80::216:36FF:FEB5:48DF
FE80::230:65FF:FE98:BFAC
FE80::280:C8FF:FE25:9050
FE80::2D0:BAFF:FEF4:3282
Total Entries: 4
State:
(I) means Incomplete state. (R) means Reachable state.
(S) means Stale state.
(P) means Probe state.
DAS-3626:admin#
To display the IPv6 neighbors of a configured IP interface:
config ipv6 nd ns ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the retrans time of a configured IP interface:
DAS-3626:admin#config ipv6 nd ns ipif System retrans_time 1000000
Command: config ipv6 nd ns ipif System retrans_time 1000000
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Link Layer Address Interface
------------------ ------------ -----
00-16-36-B5-48-DF
00-30-65-98-BF-AC
00-80-C8-25-90-50
00-D0-BA-F4-32-82
(D) means Delay state.
(T) means Static state.
Used to configure the parameters for Neighbor solicitation messages to be sent from the
switch.
config ipv6 nd ns ipif <ipif_name 12> retrans_time <uint 0-4294967295>
This command will configure the parameters for Neighbor Solicitation
messages sent from the switch. These messages are used to detect IPv6
neighbors on the switch.
<ipif_name 12> – Enter the IPv6 interface name for which to dispatch Neighbor solicitation
messages.
retrans_time <uint 0-4294967295> – Use this field to set the interval, in
milliseconds that the Switch will produce Neighbor Solicitation packets to be sent out over the
local network. This is used to discover IPv6 neighbors on the local link. The user may select a
time between 0 and 4294967295 milliseconds. Very fast intervals, represented by a low
number, are not recommended for this field.
Only Administrator-level users can issue this command.
System
System
System
System
52
State
S
S
S
S
Advertisement
Table of Contents
