D-Link DAS-3636 Cli Reference Manual page 174

show igmp_snooping rate_limit
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show rate limitation:
DAS-3626:admin#show igmp_snooping rate_limit ports 1
Command: show igmp_snooping rate_limit ports 1
Port Rate Limitation
-------- ---------------
1 No Limitation
Total Entries: 1
DAS-3626:admin#
config igmp_snooping rate_limit
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure rate limitation:
DAS-3626:admin#config igmp_snooping rate_limit ports 1 100
Command: config igmp_snooping rate_limit ports 1 100
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to show rate limitation.
show igmp_snooping rate_limit [ports <portlist>|vlanid <vlanid_list>]
This command is used to display the rate of IGMP control packet that is allowed per port or
VLAN.
<portlist> − Specifies a port or range of ports that will be displayed.
<vlanid_list> − Specifies a VLAN or range of VLANs that will be displayed.
Only Administrator and Operator-level users can issue this command.
Used to show rate limitation.
config igmp_snooping rate_limit [ports <portlist>|vlanid <vlanid_list>] [<value 1-1000>
| no_limit]
This command is used to configure the rate of IGMP control packets that are allowed per port
or VLAN.
<portlist> − Specifies a port or range of ports that will be displayed.
<vlanid_list> − Specifies a VLAN or range of VLANs that will be displayed.
<value 1-1000> − Specifies the rate of IGMP control packet that the switch can process on a
specific port. The rate is specified in packets per second. The packets that exceeds the
limited rate will be dropped. The default setting is no_limit.
no_limit – Allows users to configure the rate limitation to no limit.
Only Administrator and Operator-level users can issue this command.
169