Time And Sntp Commands - D-Link DAS-3636 Cli Reference Manual

The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
show sntp
enable sntp
disable sntp
config time <date ddmmmyyyy > <time hh:mm:ss >
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min <minute 0-59>}
[disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-4,last> | e-day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
config dst
120]} | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time <start_time
hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> |
offset [30 | 60 | 90 | 120]}]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure SNTP settings:
DAS-3626:admin#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to setup SNTP service.
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}
This command is used to configure SNTP service from an SNTP server. SNTP must be
enabled for this command to function (See enable sntp).
primary − This is the primary server from which the SNTP information will be taken.
<ipaddr> − The IP address of the primary server.
secondary − This is the secondary server the SNTP information will be taken from in the
event the primary server is unavailable.
<ipaddr> − The IP address for the secondary server.
poll-interval <int 30-99999> − This is the interval between requests for updated SNTP
information. The polling interval ranges from 30 to 99,999 seconds.
Only Administrator and Operator-level users can issue this command. SNTP service must be
enabled for this command to function (enable sntp).
T
IME AND
120
16
SNTP C
OMMANDS