Table of Contents
Advertisement
In the above example, the command config account was entered without the required parameter <username>, the CLI returned
the Next possible completions: <username> prompt. The up arrow cursor control key was pressed to re-enter the previous
command (config account) at the command prompt. Now the appropriate username can be entered and the config account
command re-executed.
All commands in the CLI function in this way. In addition, the syntax of the help prompts are the same as presented in this manual
− angle brackets < > indicate a numerical value or character string, braces { } indicate optional parameters or a choice of
parameters, and brackets [ ] indicate required parameters.
If a command is entered that is unrecognized by the CLI, the top-level commands will be displayed under the Available
commands: prompt.
DAS-3626:admin#the
Available commands:
..
clear
disable
logout
reconfig
upload
DAS-3626:admin#
The top-level commands consist of commands such as show or config. Most of these commands require one or more parameters
to narrow the top-level command. This is equivalent to show what? or config what? Where the what? is the next parameter.
For example, if users enter the show command with no additional parameters, the CLI will then display all of the possible next
parameters.
DAS-3626:admin#show
Command: show
Next possible completions:
802.1p
accounting
attack_log
authen_policy
bpdu-filter
current_config
dscp_replace_priority
fdb
gvrp
ipif_ipv6_link_local_auto
jumbo_frame
link_aggregation
log_support_module
mac_spoof_detect
mirror
multicast_fdb
port_vlan
radius
safeguard_engine
serial_port
ssh
syslog
time
traffic_segmentation
vdsl
vlan_translation_profile
DAS-3626:admin#
In the above example, all of the possible next parameters for the show command are displayed. At the next command prompt, the
up arrow was used to re-enter the show command, followed by the account parameter. The CLI then displays the user accounts
configured on the Switch.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
?
config
download
ping
reset
Figure 2-5. The Next Available Commands Prompt
802.1x
alarm
authen
authentication
cfm
dhcp_relay
filter
hardware
lacp_port
log
max_mcast_group
mld_snooping
packet
ports
ratelimit
scheduling
session
ssl
system_severity
time_range
vlan
Figure 2-6. Next possible completions: Show Command
cfm
create
enable
ping6
save
access_profile
arpentry
authen_enable
authorization
command_history
dot1v_protocol_group
error
firmware
igmp_snooping
iproute
limited_multicast_addr
log_save_timing
loopdetect
mcast_filter_profile
module_info
port
pvid
rmt
scheduling_mechanism
snmp
stp
system_usage_threshold
traffic
trusted_host
vlan_counter
vlan_trunk
5
delete
login
reboot
show
account
asymmetric_vlan
authen_login
bandwidth_control
config
external_alarm
greeting_message
ipif
ipv6
lpr
multicast
port_security
qinq
router_ports
sntp
switch
utilization
vlan_translation
Advertisement
Table of Contents
