D-Link DAS-3636 Cli Reference Manual page 300

show port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the port security configuration:
DAS-3626:admin#show port_security ports 1-5
Command: show port_security ports 1-5
Port Configuration:
Port State
----- --------
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
DAS-3626:admin#
enable port_security trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the port security trap/log setting:
DAS-3626:admin#enable port_security trap_log
Command: enable port_security trap_log
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to display the current port security configuration.
show port_security_entry { ports <portlist>}
This command is used to display port security information of the Switch's ports. The
information displayed includes port security, admin state, maximum number of learning
address and lock mode.
<portlist> − Specifies a port or range of ports to be viewed.
None.
Lock Address Mode
-----------------
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
DeleteOnReset
Used to enable the trap/log for port security.
enable port_security trap_log
This command is used to enable port security traps/logs. When this command is enabled, if
there's a new MAC that violates the pre-defined port security configuration, a trap will be sent
out with the MAC and port informationt and the relevant information will be logged.
None.
Only Administrator and Operator-level users can issue this command.
Max. Learning Addr.
-------------------
1
1
1
1
1
295