The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
Parameters
config ports
[ <portlist>| all ] {medium_type[fiber|copper]} { speed [auto | 10_half | 10_full | 100_half |
100_full | 1000_full{master|slave}] | flow_control [enable | disable] | learning [enable | disable ]|
state [enable | disable ] | [description <desc 1-32 > | clear_description]}
show ports
{[<portlist>]} {[description | err_disabled]}
enable
jumbo_frame
disable
jumbo_frame
show
jumbo_frame
Each command is listed, in detail, in the following sections.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
S
WITCH
61
11
P
C
ORT
OMMANDS