D-Link DAS-3636 Cli Reference Manual page 151

config port dot1v
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
The example is to assign VLAN marketing-1 for untaged IPv6 packet ingress from port 3
To configure the group ID 1 on port 3 to be associated with VLAN marketing-1:
DAS-3626:admin#config port dot1v ports 3 add protocol_group group_id 1 vlan
marketing_1
Command: config port dot1v ports 3 add protocol_group group_id 1 vlan marketing_1
Success.
DAS-3626:admin#
show port dot1v
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
The example display the protocol VLAN information for ports 1-2:
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Assign the VLAN for untagged packets ingress from the portlist based on the protocol group
configured.
config port dot1v ports [<portlist> | all] [add protocol_group [group_id <id>|
group_name <name 32>] [vlan < vlan_name 32> | vlanid <id 1-16>] {priority <value 0-
7>} | delete protocol_group [group_id <id 1-16>|all]]
This command is used to assign the VLAN for untagged packets ingress from the portlist
based on the protocol group configured. This assignment can be removed by using delete
protocol_group option.
When priority is not specified in the command, the port default prority will be the priority for
those untagged packets classified by the protocol vlan.
<portlist> − Specifies a range of ports to apply this command.
group_id − The id of protocol group which is used to identify a set of protocols.
group_name − The name of the protocol group. The maximum length is 32 characters.
vlan − Vlan that is to be associated with this protocol group on this port.
vlan_id − Specifies the VLAN id.
priority − Specifies the priority to be associated with the packet which has been classified to
the specified vlan by the protocol.
Only Administrator and Operator-level users can issue this command.
Display the VLAN to be associated with untagged packet ingressed from a port based on the
protocol group.
show port dot1v{ ports <portlist>}
This command is used to display the VLAN to be associated with untagged packet ingressed
from a port based on the protocol group.
portlist − Specifies a range of ports to apply this command.
None.
146