D-Link DAS-3636 Cli Reference Manual page 197

Each command is listed, in detail, in the following sections.
config mld_snooping
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the MLD snooping to the default vlan with noted_timeout 250 sec and state enable:
DAS-3626:admin#config mld_snooping vlan default state enable
Command: config mld_snooping vlan default state enable
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure MLD snooping on the switch.
config mld_snooping [ vlan <vlan_name 32> | vlanid <vidlist> |all ] { state [enable|
disable] | fast_done [enable|disable] | report_suppression [enable | disable]}
This command is used to configure MLD snooping on the switch. If the MLD version is
configured with a lower version, the higher version's MLD Report/Leave messages will be
ignored.
vlan_name − The name of the VLAN for which MLD snooping is to be configured.
vidlist – The VIDs of the VLAN for which MLD snooping is to be configured.
all − Specifies that all VLANs configured on the switch will be configured.
state – Allows the user to enable or disable the MLD snooping function for the chosed VLAN.
fast_done − enable or disable MLD snooping fast_done function.If enable, the membership is
immediately removed when the system receive the MLD done message.
report suppression – Enables or Disables MLD snooping report suppression function. If
enabled, multiple MLD reports are done for a specific (S,G) and will be intregrated into one
report only before sending to the router port.
Only Administrator and Operator-level users can issue this command.
192