Table of Contents
Advertisement
config time_range
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config time range:
DAS-3626:admin#config time_range 1-3_new hours start_time 11:21:20 end_time 11:44:40
weekdays mon-fri
Command: config time_range 1-3_new hours start_time 11:21:20 end_time 11:44:40
weekdays mon-fri
Success.
DAS-3626:admin#
show time_range
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the time range on the Switch:
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure the range of time to activate a function on the switch.
config time_range <range_name 32> [ hours start_time < time hh:mm:ss > end_time<
time hh:mm:ss > weekdays <daylist> | delete]
This command defines a specific range of time to activate a function on the Switch by
specifying which time range in a day and which days in a week are covered in the time range.
Note that the specified time range is based on SNTP time or configured time. If this time is
not available, then the time range will not be met.
range_name − Specifies the name of the time range settings.
start_time − Specifies the starting time in a day. (24-hr time)
For example, 19:00 means 7PM. 19 is also acceptable. start_time must be smaller than
end_time.
end_time − Specifies the ending time in a day. (24-hr time)
weekdays − Specify the list of days contained in the time range. Use a dash to define a
period of days. Use a comma to separate specific days.
For example, mon-fri (Monday to Friday)
sun, mon, fri (Sunday, Monday and Friday)
delete − Deletes a time range profile. When a time_range profile has been associated with
ACL entries, the delete of this time_range profile will fail.
Only Administrator and Operator-level users can issue this command.
Used to display current access list table.
show time_range
This command is used to display current time range setting.
None.
None.
407
Advertisement
Table of Contents
