D-Link DAS-3636 Cli Reference Manual page 205

Vdsl2 switch release 1.00
Table of Contents

Advertisement

Example usage:
To view the current MLD snooping static group information:
DAS-3626:admin#show mld_snooping static_group
Command: show mld_snooping static_group
VLAN ID/Name
--------------------------
1
/default
1
/default
Total Entries : 2
DAS-3626:admin#
create mld_snooping static_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static group FF12::1 for VID 1:
DAS-3626:admin#create mld_snooping static_group vlanid 1 FF12::1
Command: create mld_snooping static_group vlanid 1 FF12::1
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
IP Address
-------------------
FF12::1
FF12::2
Used to display the current MLD snooping static group information on the Switch.
create mld_snooping static_group [ vlan <vlan_name 32> | vlanid <vlanid_list> ]
<ipv6addr>
This command is used to create a mld snooping static group. Member ports can be added to
the static group. The static member and the dynamic member port form the member ports of
a group.
The static group will only take effect when MLD snooping is enabled on the VLAN. For those
static member ports, the device needs to emulate the MLD protocol operation to the querier,
and forward the traffic destined to the multicast group to the member ports.
For a layer 3 device, the device is also responsible to route the packet destined for this
specific group to static member ports.
The static member port will only affect V1 MLD operation.
The Reserved IP multicast address FF0E::X must be excluded from the configured group.
The VLAN must be created first before a static group can be created.
<vlan_name 32> − The name of the VLAN for which to create MLD snooping static group
information.
<vlanid_list> − The list of the VLAN IDs for which to create MLD snooping static group
information.
< ipv6addr > − The static group IPv6 address for which to create MLD snooping static group
information.
Only Administrator and Operator-level users can issue this command.
Static Member Ports
----------------
3
3
200

Advertisement

Table of Contents
loading

Table of Contents