D-Link DAS-3636 Cli Reference Manual page 467

To show Syslog host information:
DAS-3626:admin#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address Severity
------- --------------- ---------- --------
1 10.1.1.2
2 10.40.2.3
3 10.21.13.1
Total Entries : 3
DAS-3626:admin#
config log_save_timing
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure log_save_timing:
DAS-3626:admin#config log_save_timing on_demand
Command: config log_save_timing on_demand
Success.
DAS-3626:admin#
show log_save_timing
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
All
All
All
Used to configure the method to save log.
config log_save_timing [time_interval <min 1-65535> | on_demand | log_trigger]
This command is used to set the method to save log.
time_interval − save log to flash every xxx minutes. (if no log happen in this period, don't
save)
on_demand − save log to flash whenever user type "save log" or "save all" This is also the
default.
log_trigger − save log to flash whenever log arrives
Only Administrator and Operator-level users can issue this command.
Used to show the timing method to save log.
show log_save_timing
This command is used to show method to save log.
None.
None.
Facility UDP port
--------
Local0 514
Local0 514
Local0 514
462
Status
--------
Disabled
Disabled
Disabled