Basic Ip Commands - D-Link DAS-3636 Cli Reference Manual

The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ipif
show ipif
enable ipif
disable ipif
enable ipif_ipv6_link_local_auto
disable ipif_ipv6_link_local_auto
show ipif_ipv6_link_local_auto
Each command is listed, in detail, in the following sections.
*See Switch Utility Commands for descriptions of all autoconfig commands.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Parameters
<ipif_name 12> [{ipaddress <network_address> |vlan <vlan_name 32> |state
[ enable |disable]} | bootp |dhcp | ipv6 [ipv6address <ipv6networkaddr> | state
[enable| disable]] |ipv4 state [enable | disable]]
{<ipif_name 12>}
[<ipif_name 12> | all]
[<ipif_name 12> | all ]
[<ipif_name 12> | all ]
[<ipif_name 12> | all ]
{<ipif_name 12>}
44
B IP C
ASIC OMMANDS
7