Table of Contents
Advertisement
DAS-3626:admin#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DAS-3626:admin#
config dst
Purpose
Used to enable and configure time adjustments to allow for the use of Daylight Savings Time
(DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day <start_day sun-
sat> | s_mth <start_mth 1-12> | s_time start_time hh:mm> | e_week <end_week 1-
4,last> | e_day <end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm>
| offset [30 | 60 | 90 | 120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> |
e_time <end_time hh:mm> | offset [30 | 60 | 90 | 120]}]
Description
This command is used to enable and configure DST. When enabled this will adjust the
system clock to comply with any DST requirement. DST adjustment effects system time for
both manually configured time and time set using SNTP service.
disable − Disable the DST seasonal time adjustment for the Switch.
repeating − Using repeating mode will enable DST seasonal time adjustment. Repeating
mode requires that the DST beginning and ending date be specified using a formula. For
example, specify to begin DST on Saturday during the second week of April and end DST on
Sunday during the last week of October.
annual − Using annual mode will enable DST seasonal time adjustment. Annual mode
requires that the DST beginning and ending date be specified concisely. For example, specify
to begin DST on April 3 and end DST on October 14.
s_week − Configure the week of the month in which DST begins.
e_week − Configure the week of the month in which DST ends.
Parameters
s_day – Configure the day of the week in which DST begins.
e_day − Configure the day of the week in which DST ends.
s_mth − Configure the month in which DST begins.
e_mth − Configure the month in which DST ends.
s_time – Configure the time of day to begin DST.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
•
<start_week 1-4,last> − The number of the week during the month in which DST
begins where 1 is the first week, 2 is the second week and so on, last is the last
week of the month.
•
<end_week 1-4,last> − The number of the week during the month in which DST
ends where 1 is the first week, 2 is the second week and so on, last is the last week
of the month.
•
<start_day sun-sat> − The day of the week in which DST begins expressed using a
three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
•
<end_day sun-sat> − The day of the week in which DST ends expressed using a
three character abbreviation (sun, mon, tue, wed, thu, fri, sat)
•
<start_mth 1-12> − The month to begin DST expressed as a number.
•
<end_mth 1-12> − The month to end DST expressed as a number.
•
<start_time hh:mm> − Time is expressed using a 24-hour clock, in hours and
minutes.
123
Advertisement
Table of Contents
