D-Link DAS-3636 Cli Reference Manual page 185

create igmp_snooping multicast_vlan_group_profile
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create an IGMP multicast VLAN group profile "p1":
DAS-3626:admin#create igmp_snooping multicast_vlan_group_profile p1
Command: create igmp_snooping multicast_vlan_group_profile p1
Success.
DAS-3626:admin#
config igmp_snooping multicast_vlan_group_profile
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add 233.1.1.1 to 266.1.1.1 to IGMP multicast VLAN group profile "p1":
DAS-3626:admin#config igmp_snooping multicast_vlan_group_profile p1 add 225.1.1.1-
226.1.1.1
Command: config igmp_snooping multicast_vlan_group_profile p1 add 225.1.1.1-
226.1.1.1
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to create an IGMP Multicast VLAN group profile on the switch.
create igmp_snooping multicast_vlan_group_profile <profile_name 1-32>
This command is used to create an IGMP Multicast VLAN group profile. The profile name
cannot be used for IGMP snooping or MLD snooping.
<profile_name 32> − Specifies the IPv4 multicast VLAN group profile name, max length is 32.
If not specified, all IPv4 multicast VLAN group profiles will be displayed.
Only Administrator and Operator-level users can issue this command.
Used to configure an IGMP Multicast VLAN group profile on the switch, to add or delete
multicast address on the profile.
config igmp_snooping multicast_vlan_group_profile <profile_name 1-32> [add | delete]
<mcast_address_list>
This command configures an IGMP Multicast VLAN group profile on the switch, to add or
delete multicast address for the profile.
<profile_name 32> − Specifies the IGMP Multicast VLAN group profile name, max length is
32.
[add | delete] – Add or delete IGMP Multicast address list to or from this multicast VLAN
group profile
<mcast_address_list> – Specifies the IGMP Multicast addresses to be configured. It can be
continuous single multicast addresses, such as 225.1.1.1, 225.1.1.3, 225.1.1.8, or a multicast
address range, such as 225.1.1.1-225.2.2.2, or both of them, such as 225.1.1.1, 225.1.1.18-
225.1.1.20
Only Administrator and Operator-level users can issue this command.
180