D-Link DAS-3636 Cli Reference Manual page 161

delete link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete link aggregation group:
DAS-3626:admin#delete link_aggregation group_id 2
Command: delete link_aggregation group_id 2
Success.
DAS-3626:admin#
config link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7, 9:
DAS-3626:admin#config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Command: config link_aggregation group_id 1 master_port 5 ports 5-7, 9
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to delete a previously configured link aggregation group.
delete link_aggregation group_id <value 1-6>
This command is used to delete a previously configured link aggregation group.
<value 1-6> − Specifies the group ID. The Switch allows up to six link aggregation groups to
be configured. The group number identifies each of the groups.
Only Administrator and Operator-level users can issue this command.
Used to configure a previously created link aggregation group.
config link_aggregation group_id <value 1-6> {master_port <port> | ports <portlist> |
state [enable | disable] }
This command allows users to configure a link aggregation group that was created with the
create link_aggregation command above.
group _id <value 1-6> − Specifies the group ID. The Switch allows up to 6 link aggregation
groups to be configured. The group number identifies each of the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of the link
aggregation group will be the master port. All of the ports in a link aggregation group will
share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link aggregation
group.
state [enable | disable] − Allows users to enable or disable the specified link aggregation
group.
Only Administrator and Operator-level users can issue this command. Link aggregation
groups may not overlap. VDSL ports cannot be used for link aggreagation.
156