Table of Contents
Advertisement
show cfm fault
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display CFM fault:
DAS-3600-12:4#show cfm mep fault
Command: show cfm mep fault
MD Name
MA Name
----------- ----------- ----- ---------------------------
op_domain
op1
DAS-3600-12:4#
show cfm port
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display CFM ports:
DAS-3600-12:4#show cfm port 1
Command: show cfm port 1
MAC Address: 10:10:90:08:8g:12
MD Name
MA Name
----------- ----------- ----- ----- --------- ----
op_domain
op1
cust_domain cust1
serv_domain serv2
DAS-3600-12:4#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
This command is used to show fault MEPs.
show cfm fault {md <string 22> {ma <string 22>}}
This command is used to display all the fault conditions detected by the MEPs contained in
the specified MA or MD. This display provides the overview of fault status by MEPs.
md – Specifies the maintenance domain name.
ma – Specifies the maintenance domain name.
None.
MEPID
Status
1
Cross-connect CCM Received
This command is used to show MEPs and MIPs created on a port.
show cfm port <port> {level <int 0-7> | direction [inward | outward] | vlanid <vlanid 1-
4094>}
This command is used to show MEPs and MIPs created on a port.
port – Specifies the port number.
level – Specifies the MD Level. If not specified, all levels are shown.
direction – Specifies the MEP direction.
inward – Inward facing MEP.
outward – Outward facing MEP.
If not specified, both directions and MIPs are shown.
Vlanid – VLAN identifier. If not specified, all VLANs are shown.
None.
MEPID Level Direction VID
1
2
8
4
MIP
3
inward
2
inward
2
2
266
Advertisement
Table of Contents
