Table of Contents
Advertisement
Example usage:
To download a configuration file:
DAS-3626:admin#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DAS-3626:admin#
DAS-3626:admin##----------------------------------------------------------
DAS-3626:admin##
DAS-3626:admin##
DAS-3626:admin##
DAS-3626:admin##Copyright(C) 2009 D-Link Corporation. All rights reserved.
DAS-3626:admin##----------------------------------------------------------
DAS-3626:admin#
DAS-3626:admin#
DAS-3626:admin## BASIC
DAS-3626:admin#
DAS-3626:admin#config serial_port baud_rate 115200 auto_logout 10_minutes
Command: config serial_port baud_rate 115200 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DAS-3600-12" appears followed by the
command prompt.
DAS-3626:admin#disable authen_policy
Command: disable authen_policy
Success.
DAS-3626:admin#
DAS-3626:admin##-------------------------------------------------------
DAS-3626:admin##
DAS-3626:admin##-------------------------------------------------------
DAS-3626:admin#
config firmware
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
DAS-3626 VDSL2 Configuration
Firmware: Build 1.00.B042
End of configuration file for DAS-3600-12
Used to configure the firmware section as a boot up section, or to delete the firmware section
config firmware image_id <int 1-2> [delete | boot_up]
This command is used to configure the firmware section. The user may choose to remove the
firmware section or use it as a boot up section.
image_id – Specifies the working section. The Switch can hold two firmware versions for the
user to select from, which are specified by image ID.
delete – Entering this parameter will delete the specified firmware section.
boot_up – Entering this parameter will specify the firmware image ID as a boot up section.
Only Administrator-level users can issue this command.
38
Advertisement
Table of Contents
