Table of Contents
Advertisement
config dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To config DHCP relay:
DAS-3626:admin#config dhcp_relay hops 2 time 23
Command: config dhcp_relay hops 2 time 23
Success.
DAS-3626:admin#
config dhcp_relay add ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an IP destination to the DHCP relay table:
DAS-3626:admin#config dhcp_relay add ipif System 10.58.44.6
Command: config dhcp_relay add ipif System 10.58.44.6
Success.
DAS-3626:admin#
config dhcp_relay delete ipif
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure the DHCP/BOOTP relay feature of the switch.
config dhcp_relay {hops <value 1-16> | time <sec 0-65535>}
This command is used to configure the DHCP/BOOTP relay feature.
hops <value 1-16> − Specifies the maximum number of relay agent hops that the DHCP
packets can cross.
time <sec 0-65535> − If this time is exceeded, the Switch will relay the DHCP packet.
Only Administrator and Operator-level users can issue this command.
Used to add an IP destination address to the switch's DHCP/BOOTP relay table.
config dhcp_relay add ipif <ipif_name 12> <ipaddr>
This command adds an IP address as a destination to forward (relay) DHCP/BOOTP relay
packets to.
<ipif_name 12> − The name of the IP interface in which DHCP relay is to be enabled.
<ipaddr> − The DHCP server IP address.
Only Administrator and Operator-level users can issue this command.
Used to delete one or all IP destination addresses from the Switch's DHCP/BOOTP relay
table.
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
This command is used to delete an IP destination addresses in the Switch's DHCP/BOOTP
relay table.
<ipif_name 12> − The name of the IP interface that contains the IP address below.
<ipaddr> − The DHCP server IP address.
Only Administrator and Operator-level users can issue this command.
79
Advertisement
Table of Contents
