xStack
The IPv6 Neighbor Discover commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create ipv6 neighbor_cache ipif
delete ipv6 neighbor_cache ipif
show ipv6 neighbor_cache ipif
config ipv6 nd ns ipif
config ipv6 nd ra ipif
config ipv6 nd ra prefix_option ipif
show ipv6 nd
Each command is listed, in detail, in the following sections.
create ipv6 neighbor_cache
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a static neighbor cache entry on the interface System, with an IPv6 address of 3ffc::1 and a MAC address of
00:01:02L03:04:05:
DGS-3627:admin# create ipv6 neighbor_cache ipif System 3ffc::1
Command: create ipv6 neighbor System _cache ipif 3FFC::1 00:01:02:03:04:05
Success.
DGS-3627:admin#
®
DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
IPV6 NEIGHBOR DISCOVER COMMANDS
Parameters
<ipif_name 12> <ipv6addr> <macaddr>
[<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
[<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic | all]
<ipif_name 12> retrans_time <millisecond 0-4294967295>
<ipif_name 12> {state [enable | disable] | life_time <sec 0-9000> |
reachable_time < millisecond 0-3600000> | retrans_time <millisecond 0-
4294967295> | hop_limit <value 0-255> | managed_flag [enable | disable] |
other_config_flag [enable | disable] | min_rtr_adv_interval <sec 3-1350> |
max_rtr_adv_interval <sec 4-1800>} (1)
<ipif_name 12> <ipv6networkaddr> {preferred_life_time <sec 0-4294967295> |
valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]} (1)
{ipif <ipif_name 12>}
Adds a static neighbor on an IPv6 interface.
create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Adds a static neighbor on an IPv6 interface.
ipif_name - Interface's name.
ipv6addr - The address of the neighbor.
macaddr - The MAC address of the neighbor.
Only Administrator and Operator-level users can issue this command.
365
47
00:01:02:03:04:05