D-Link DAS-3636 Cli Reference Manual page 56

delete ipv6 neighbor_cache ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To delete a static IPv6 neighbor:
DAS-3626:admin#delete ipv6 neighbor_cache ipif
Command: delete ipv6 neighbor_cache ipif
Success.
DAS-3626:admin#
show ipv6 neighbor_cache ipif
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to remove a static IPv6 neighbor.
delete ipv6 neighbor_cache ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic |
all]
This command is used to remove a static IPv6 neighbor from an existing IPv6 interface
previously created on the switch.
<ipif_name 12> – Enter the IPv6 interface name previously created using the create ipif
commands.
all – Enter this parameter to denote all IPv6 interfaces created on the switch.
<ipv6addr> – Enter the IPv6 address of the neighbor device to be removed from being an
IPv6 neighbor of the IP interface previously entered in this command.
static – Enter this command to remove all statically configured neighbor
devices from being an IPv6 neighbor of the IP interface previously entered.
dynamic – Enter this command to remove all dynamically configured neighbor devices from
being an IPv6 neighbor of the IP interface previously entered.
all – Enter this parameter to remove all IPv6 neighbors of the switch.
Only Administrator-level users can issue this command.
Used to view the neighbor cache of an IPv6 interface located on the Switch.
show ipv6 neighbor_cache ipif [<ipif_name 12> | all] | [ipv6address
<ipv6addr> | static | dynamic | all]
This command is used to display the IPv6 neighbors of a configured IPv6 interface currently
set on the switch. Users may specify an IP interface, IPv6 address or statically entered IPv6
addresses by which to view the neighbor cache.
<ipif_name 12> – Enter the IP interface for which to view IPv6 neighbors. This will display all
IPv6 neighbors of this interface.
all – Enter this parameter to denote all IPv6 interfaces created on the switch.
ipv6address <ipv6addr> – Enter the IPv6 address of the neighbor by which to view this
information.
static – Enter this parameter to view all statically entered IPv6 neighbors of the switch.
dynamic – Enter this command to view all dynamically configured neighbor devices which are
IPv6 neighbors of the IP interface previously entered.
all – Enter this parameter to view all configured neighbor devices which are IPv6 neighbors of
the IP interface previously entered.
None.
System 3FFC::1
System 3FFC::1
51