Table of Contents
Advertisement
show syslog
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the current status of the syslog function:
DAS-3626:admin#show syslog
Command: show syslog
Syslog Global State: Enabled
DAS-3626:admin#
create syslog host
Purpose
Syntax
Description
Parameters
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to display the syslog protocol status as enabled or disabled.
show syslog
This command is used to display the syslog status as enabled or disabled.
None.
None.
Used to create a new syslog host.
create syslog host <index 1-4> ipaddress <ipaddr> {severity [informational | warning |
all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number> | state [enable | disable]
This command is used to create a new syslog host.
<index 1-4> − Specifies that the command will be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
ipaddress <ipaddr> − Specifies the IP address of the remote host where syslog messages
will be sent.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported on the Switch.
Numerical
Severity
Code
0
Emergency: system is unusable
1
Alert: action must be taken immediately
2
Critical: critical conditions
3
Error: error conditions
4
Warning: warning conditions
5
Notice: normal but significant condition
6
Informational: informational messages
7
Debug: debug-level messages
Numerical
Facility
Code
457
Advertisement
Table of Contents
