D-Link DAS-3636 Cli Reference Manual page 162

config link_aggregation algorithm
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure link aggregation algorithm for mac-source-dest:
DAS-3626:admin#config link_aggregation algorithm mac_source_dest
Command: config link_aggregation algorithm mac_source_dest
Success.
DAS-3626:admin#
show link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display Link Aggregation configuration:
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure the link aggregation algorithm.
config link_aggregation algorithm [mac_source | mac_destination | mac_source_dest |
ip_source | ip_destination | ip_source_dest]
This command configures the part of the packet examined by the Switch when selecting the
egress port for transmitting load-sharing data. This feature is only available using the
address-based load-sharing algorithm.
mac_source − Indicates that the Switch should examine the MAC source address.
mac_destination − Indicates that the Switch should examine the MAC destination address.
mac_source_dest − Indicates that the Switch should examine the MAC source and
destination addresses.
ip_source − Indicates that the Switch should examine the IP source address.
ip_destination − Indicates that the Switch should examine the IP destination address.
ip_source_dest − Indicates that the Switch should examine the IP source address and the
destination address.
Only Administrator and Operator-level users can issue this command.
Used to display the current link aggregation configuration on the Switch.
show link_aggregation {group_id <value 1-6> | algorithm}
This command will display the current link aggregation configuration of the Switch.
<value 1-6> − Specifies the group ID. The Switch allows up to 6 link aggregation groups to be
configured. The group number identifies each of the groups.
algorithm − Allows users to specify the display of link aggregation by the algorithm in use by
that group.
None.
157