Ipv6 Neighbor Discover Commands - D-Link xStack DES-3528 Series Cli Reference Manual

xStack® DES-3528/DES-3552 Series Layer 2 Managed Stackable Fast Ethernet Switch CLI Reference Guide

IPv6 Neighbor Discover Commands

The IPv6 Neighbor Discover commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
create ipv6 neighbor_cache
delete ipv6 neighbor_cache
show ipv6 neighbor_cache
config ipv6 nd ns
show ipv6 nd
Each command is listed, in detail, in the following sections.
create ipv6 neighbor_cache
Purpose
Add a static neighbor on an IPv6 interface.
Syntax create ipv6 neighbor_cache ipif <ipif_name 12> <ipv6addr> <macaddr>
Description Add a static neighbor on an IPv6 interface.
Parameters ipif - Specifies the interface's name.
<ipif_name 12> - Enter the IP interface name here. This name can be up to 12 characters
long.
<ipv6addr> - The address of the neighbor.
<macaddr> - The MAC address of the neighbor.
Restrictions Only Administrator, Operator and Power User-level users can issue this command.
Example usage:
Create a static neighbor cache entry:
DES-3528:admin#
Command: create ipv6 neighbor System _cache ipif 3FFC::1 00:01:02:03:04:05
Success.
DES-3528:admin#
Parameters
ipif <ipif_name 12> <ipv6addr> <macaddr>
ipif [<ipif_name 12> | all] [<ipv6addr> | static | dynamic | all]
ipif [<ipif_name 12> | all] [ipv6address <ipv6addr> | static | dynamic | all]
{hardware}
ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
{ipif <ipif_name 12>}
create ipv6 neighbor_cache ipif System 3ffc::1
545
00:01:02:03:04:05