Network Monitoring Commands - D-Link DAS-3636 Cli Reference Manual

The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
show packet ports
show error ports
show utilization
show utilization dram
show utilization flash
clear counters
clear log
show log
enable syslog
disable syslog
show syslog
create syslog host
config syslog host
delete syslog host
show syslog host
config log_save_timing
show log_save_timing
show attack_log
clear attack_log
upload attack_log_toTFTP
config system_severity
show system_severity
Each command is listed, in detail, in the following sections.
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Parameters
<portlist>
<portlist>
[cpu | ports {<portlist>}]
{ports <portlist>}
{index <value_list> }
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility
[local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port
<udp_port_number>| state [enable | disable]
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 |
local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> |
ipaddress <ipaddr> | state [enable | disable]}
[<index 1-4> | all]
{<index 1-4>}
time_interval <min 1-65535> | on_demand | log_trigger]
[
{index <value_list>}
[<ipaddr>|<ipv6addr>] <path_filename 64>
[trap | log | all] [critical | warning | information]
N M
ETWORK
440
C
ONITORING OMMANDS
40