Link Aggregation Commands - D-Link DAS-3636 Cli Reference Manual

The link aggregation commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create link_aggregation
delete link_aggregation
config link_aggregation
config link_aggregation
algorithm
show link_aggregation
config lacp_port
show lacp_port
Each command is listed, in detail, in the following sections.
create link_aggregation
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To create a link aggregation group:
DAS-3626:admin#create link_aggregation group_id 2
Command: create link_aggregation group_id 2
Success.
DAS-3626:admin#
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Parameters
group_id <value 1-6> {type [lacp | static]}
group_id <value 1-6>
group_id <value 1-6> {master_port <port> | ports <portlist> | state [enable | disable]}
[mac_source | mac_destination | mac_source_dest | ip_source | ip_destination |
ip_source_dest]
{group_id <value 1-6> | algorithm}
<portlist> mode [active | passive]
{<portlist>}
Used to create a link aggregation group on the Switch.
create link_aggregation group_id <value 1-6> {type[lacp | static]}
This command will create a link aggregation group with a unique identifier.
<value> − Specifies the group ID. The Switch allows up to six link aggregation groups to be
configured. The group number identifies each of the groups.
type – Specify the type of link aggregation used for the group. If the type is not specified the
default type is static.
•
lacp – This designates the port group as LACP compliant. LACP allows dynamic
adjustment to the aggregated port group. LACP compliant ports may be further
configured (see config lacp_ports). LACP compliant must be connected to LACP
compliant devices.
•
static – This designates the aggregated port group as static. Static port groups can
not be changed as easily as LACP compliant port groups since both linked devices
must be manually configured if the configuration of the trunked group is changed. If
static link aggregation is used, be sure that both ends of the connection are
properly configured and that all ports have the same speed/duplex settings.
Only Administrator and Operator-level users can issue this command. VDSL ports cannot be
used in a link aggregation group.
L A
INK GGREGATION
155
19
C
OMMANDS