D-Link DAS-3636 Cli Reference Manual page 213

config loopdetect ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To set the loop-detect state to enable:
DAS-3626:admin#config loopdetect ports 1-5 state enabled
Command: config loopdetect ports 1-5 state enabled
Success
DAS-3626:admin#
enable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable loop-back detection on the switch:
DAS-3626:admin#enable loopdetect
Command: enable loopdetect
Success
DAS-3626:admin#
disable loopdetect
Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
Used to configure loop-back detection state of ports.
config loopdetect ports [<portlist> | all] | state [enabled | disabled]
This command is used to configure loop-back detection state of ports.
<portlist> − Specifies a range of ports for the loop-back detection
state [enabled | disabled] – Allows the loop-back detection to be disabled and enabled.
Only Administrator and Operator-level users can issue this command.
Used to globally enable loop-back detection on the switch.
enable loopdetect
This command is used to globally enable loop-back detection on the switch.
None.
Only Administrator and Operator-level users can issue this command.
Used to globally disable loop-back detection on the switch.
disable loopdetect
This command is used to globally disable loop-back detection on the switch.
None.
Only Administrator and Operator-level users can issue this command.
208