Config Authen Parameter Attempt - D-Link DAS-3636 Cli Reference Manual

Example usage:
To view authentication server groups currently set on the Switch.
DAS-3626:admin#show authen server_group
Command: show authen server_group
Server Group : mix_1
Group Name
---------------
mix_1
radius
tacacs
tacacs+
xtacacs
Total Entries : 5
DAS-3626:admin#
config authen parameter response_timeout
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the response timeout for 60 seconds:
DAS-3626:admin# config authen parameter response_timeout 60
Command: config authen parameter response_timeout 60
Success.
DAS-3626:admin#

config authen parameter attempt

Purpose
Syntax
Description
Parameters
Restrictions
DAS-3600 Series Ethernet over VDSL Switch CLI Reference Manual
IP Address Protocol
-------------- --------
10.1.1.222 TACACS+
10.1.1.223 TACACS
10.1.1.224 RADIUS
10.1.1.225 TACACS
10.1.1.226 TACACS+
10.1.1.227 XTACACS
Used to configure the amount of time the Switch will wait for a user to enter authentication
before timing out.
config authen parameter response_timeout <int 0-255>
This command will set the time the Switch will wait for a response of authentication from the
user.
response_timeout <int 0-255> − Set the time, in seconds, the Switch will wait for a response
of authentication from the user attempting to log in from the command line interface or telnet
interface. Zero means there won't be a time-out. The default value is 0 seconds.
Only Administrator-level users can issue this command.
Used to configure the maximum number of times the Switch will accept authentication
attempts.
config authen parameter attempt <int 1-255>
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of attempts will
be denied access to the Switch and will be locked out of further authentication attempts.
Command line interface users will have to wait 60 seconds before another authentication
attempt. Telnet users will be disconnected from the Switch.
parameter attempt <int 1-255> − Set the maximum number of attempts the user may try to
become authenticated by the Switch, before being locked out. The default setting is 3.
Only Administrator-level users can issue this command.
381